Getting the right image for the inspection task will get you the best results. Generally being able to clearly see all the defects is what you should optimize for. Here are some rules of thumb that will give you the best results.

<aside> 💡 Goal: The goal of imaging setup is to make the defects as clear as possible to a human looking at the images. If the object is not moving use “exposure” to increase brightness. If the object is in motion use “gain” (to reduce motion blur).

</aside>

☑️How to:

  1. Click on Configure Imaging to get started

    Untitled

  2. Toggle Auto White Balance to On

    Untitled

    <aside> 💡 Make sure to turn off Auto White Balance when you are done.

    </aside>

  3. Click on Run Autofocus

    Untitled

  4. Fine tune each setting. You can use the arrow keys or your mouse to fine tune the slider bars for each setting. Alternatively, an actual number can be entered to set individual settings.

    1. Start with Exposure —> then Gain —> and then all other variables
    2. Motion blur: if the camera is vibrating or the part is moving, you should make sure that the exposure is as low as possible. In this situation, you should use gain instead.

    Untitled (6) (1).png

  5. Reduce glare. Glare means that certain parts of the image are washed out. We can’t perform inspections in washed out areas. There are several ways to avoid glare.

Too much glare

Too much glare

Avoid pointing the camera directly at the object. Instead angle the camera at 15 degrees, so there is no direct reflection.

Screen Shot 2023-04-24 at 7.13.08 PM.png

Photometric lighting mode. This cycles through the lights and digitally stitches the image together to reduce glare.

Photometric

Photometric



  1. Toggle Auto White Balance to Off once you have set your desired image conditions.

    Untitled

  2. Save Image Settings

    Untitled



💡Tips & Best Practices

  1. Closer is better. This is because you get more pixels on the part so the AI has more data to work with.